E46 M3..possible to fit a porsche rotor&calipers?

[E46///M3]

is it possible? how much do u guys think that would cost? I've seen it done on the audi TT's before, it was a stright bolt on......... i was wondering if its possible to do the same for the M3.......and how much would that cost? any ideas? cheaper than brambos i hope...

[madtek]

......http://www.movit.de/. I think they deal with Porsche brakes...including ceramics!

[DoNDoN]

Try www.ecisbmw.com

I have their kit and i love it. They use Boxster S calipers and Euro E46 M3 rotors.

[E46///M3]

that looks FREEK'N NUTS. LOVE IT. but so expensive man! not enough $$

[Mikebike]

Those brakes are nice.. but there's something just inharently wrong about putting porsche parts on a BMW

[AWE]

Just a word of caution...

the braking efficiency is most likely disproportional to the characteristics of the vehicle when you go this route.

I suggest buying the real set specifically designed for your car - a set that has the righ size caliper piston and valving.

Not only you run the risk of either too much or too little braking power, you also have the risk of an imbalanced front-rear braking ability - which could make your car run unpredicatable.

Why go through the headache and risks? Buy the real thing!

Just my personal opinion for your safety and the safety of others at least.

[E46///M3]

damn, i did not consider this point. thx!

[TC M3]

Originally posted by E46///M3
is it possible? how much do u guys think that would cost? I've seen it done on the audi TT's before, it was a stright bolt on......... i was wondering if its possible to do the same for the M3.......and how much would that cost? any ideas? cheaper than brambos i hope...

why????