 |
| |||||||||||||||
| ||||||||||||||||||
| ||||||||||||||||||
|
| |||||||
| Register | FAQ | Members List | Calendar | Search |
 |
| | LinkBack | Thread Tools | Display Modes |
02-26-2006, 09:47 PM
| ||||
| ||||
| sparco 3 point help Will there be any drilling involved to install a sparco 3 point harness on my e36 325i. im looking at the snap on 2'' 3 point system with the buckle so i can take off when i need. i assume the two front mounting points can go directly to where the current stock seat rails are, but does the back mount need to be drilled, or does it mount to the existing buckle point on the back seat... i do still have stock seats... thank you craig      |
| |
|
02-27-2006, 06:09 PM
| ||||
| ||||
| im sure sombody has sparco straps in their ride...any advice or 2cents ANYONE....PLEASE?
__________________ H&R cup kit, BFP cais, Dinan chip, B&B exhaust system, Hm2 18'', 5 speed tranny swap lightweight driveshaft, 3.46 limited slip, 95 325 motor. i need moreeeeeeeeeee! |
|
02-28-2006, 11:25 AM
| ||||
| ||||
| they got triangle shaped plates at the end with a hole in it? if so they bolt in where the rear belts bolt in.
__________________  R.I.P. Sean Duddy 20/5/1987 - 17/2/2007 E36 #1 - Manual M40B18 318i, Sold. E36 #2 - Auto Non-Vanos 325i, Destroyed. E36 #3 - Manual M43B18 318i, Current Project. Originally Posted by LSDRider Yo yo son, check it. You best keep reppin' da originah Bemmah (zim-zeema homes) and stick wit dem originah buttah nucca.. yo.  |
|
02-28-2006, 06:11 PM
| ||||
| ||||
| yes they have the plates... and a bolt in it, thats what i thought i wa just seeing if there were any better ways. i will eventually run the bar harness though...
__________________ H&R cup kit, BFP cais, Dinan chip, B&B exhaust system, Hm2 18'', 5 speed tranny swap lightweight driveshaft, 3.46 limited slip, 95 325 motor. i need moreeeeeeeeeee! |
Linear Mode
