| Stonguard....
When I went to put the Stonguard on my ZKW the packaging said there were two ways to install it. One was the "dry" method, just stick the thing on there, and the other was the "wet" method, using soapy water underneath the vinyl. To make a long story short, I made the mistake of using the "dry" method, and while one light came out perfect, the other was pretty bad with bubbles everywhere. I took it off last night, only to find that half of the glue on the back of the vinyl stuck to the headlight, and the other half came off with the Stonguard. After much cursing and elbow grease I was able to successfully remove the glue from both the headlight and the vinyl. My question is this, is it possible to reuse this clean glue-free Stonguard on the headlight? Should I apply something to the surface to allow it to stick, or will it perhaps stick to the light through static/suction if I just use the "wet" method to reapply??
-Aaron
__________________  | 
06-01-2005, 06:12 AM
Linear Mode
