I need some help in how to properly wire two amplifiers together to Two Subs. As of right now I have an audiobahn A4002T 800 watt amp and a kenwood 600 watt. I have them wired together but for some reason the Audiobahn comes on and then the Kenwood comes on and they both cut off. I have both of the levels turned all the way down.
They way they are wired goes like this.
The audiobahn is wired normally for a power, ground, and remote. I have the RCAs coming from the deck wired in to the LINE IN and I bridged the speaker outputs(meaning one wire comes off of a positive and splits to each sub, same with the negative). For the LINE OUT on the audiobahn a set of RCAs runs to the kenwood.
The kenwood is wired normally for power, ground, and remote. I also have it bridged.
Any help would be greatly appreciated!
